Pilgrim from United States, TX Public Profile

Fit and finish are perfect. Make sure you have a 30 mm crowfoot wrench to torque the barrel nut. Great instruction paper provided by Wilson. Perfect match for my Wilson 20” Super Sniper Barrel.

Very well made and no burnishing of the mount.
Just the right Eye relief.

Purchased this to pair on my AR15 with Wilson 20 super sniper barrel. Hold POI excellent and is crystal clear at the range.

Fit my Wilson Combat barrel perfect and fit under my BRO Ancor Rail System. the brass kicks out at 3:30 perfectly. I had tried an adjustable Block but it wouldn’t fit.

So, I have a Savage Md. in a Ashbury Precision Chassis. It came with the Orange trigger. The book it came with says it’s a Law Enforcement model. The trigger has been good but some times when touched on the side it would drop the Target sear and catch on the acutrigger safety. This would mean you have to lift the bolt to reset Savages system.
Install of the Rifle Basic is straight forward and is made much better than the Savage stamped sheet metal. I could not use the lighter spring it came with as the slightest bump ( the bolt actually has a silicone rubber bumper) it would fire as now there is no extra level of safety. I had to use the heavier spring and have it set at 12 oz. It has a little creep with no adjustment but does have an adjustment for over travel. A sharp rap with a brass hammer on the receiver will fire the gun. I believe this is due to the target sear more than anything. I only use the gun at the range as it’s quite heavy with the chassis and 26” barrel. I’m still 50/50 if it’s better than stock orange trigger/target sear.