Reviews & Ratings for FM Products Foxtrot Mike Premium Match Grade 2 Stage Competition AR-15 Trigger Group — 10 reviews — Page 1

Pretty happy with this trigger so far, looking forward to a lot more range time when it is not so warm. Went in an ar10 build. Good price for a two stage trigger. Nice clean breaks and a good feel. Probably as good as the rock river two stage varmint trigger and better than bushmaster two stage national match.

Awsome trigger for the price. If you polish it which you can it becomes even better smooth as silk. The break is very clean. I dont have a gauge but I bet it's in the 3s. I would recommend this any day of the week.

This trigger is very crisp. It is much lighter than a mil-spec single stage. There may be better triggers out there, but this one is a great combination of value and functionality. I put this in my 308 AR and it feels great.

I liked my first one so much that I bought a second. It is just as good as the first. The take-up is easy and clean, and the trigger then breaks light and sharp.

I feel like this is one of the best trigger values of the available options. Price, installation and performance are thumbs up.

Really nice trigger. Smooth 4lb pull every time. For the price I would put this trigger up against anything. I have shot a lot of triggers over the years and FM has done a fantastic job with this one.

High quality trigger. The nickel boron coating is one of the key factors for the smooth action.
Great machining and qualty control is second to none.
It is an easy install. And the easy initial pull and the reset make for an easy 1st shot and a lightning
quick rest and second and subsequent follow up shots.

I highly recommend this trigger group for any AR15 or other application that may apply.

I bought this trigger for my new AR-9 build after the mil-spec trigger gave me double fires and a scary out-of-battery discharge. Research indicated that the trigger group was probably at fault, and some advice suggested a 2-stage trigger would tend to work better in a blowback PCC. Two-stage trigger operation is surprisingly different from a single-stage trigger (also note difference in hammer shape.) I suspect the "tail" of my mil-spec hammer was sometimes whacking the disconnector due to the ultra-fast bolt recoil, preventing the hammer from locking in.

Installation was easy - not really much different than any other AR trigger. Trigger and hammer are very well made. Small writing on the trigger body says "1005 Tactical."

I just got back from the range, and my AR-9 ran 150 rounds without a single firing problem!!! Trigger operation is smooth, and the break is light and fairly crisp. Takeup takes very little effort. This is my first experience with a 2-stage trigger, but I liked it very much. I may buy an extra to try in my other ARs. You really cannot beat it for the price. HIGHLY RECOMMENDED.

I am very sensitive to gritty action of a trigger group as well as the pull it takes to release the hammer
Upon inspection of this Nickle Boron coated assembly I noticed the fit and finish of the product.
Although no instruction manuel, I found that it was really not needed. It installed in 10 minutes.
The design and mass of the trigger group, along with about a two pound less pull has made me
happy with my purchase.
Upgrading my Ruger ar 556 to this trigger group was the correct choice, in my opinion.
Highly recommended!