Your Browser is Outdated
Compare (0)
1 item has been added
Add at least two items to compare
Most Helpful Positive Review
UTG Pro buffer tube
Nice quality mil spec buffer, the price of the kit is comparable to just the buffer tube from other manufacturers. The buffer spring feels a bit cheap and is not a smooth in the tube as some buffer springs that are even in the $10-20 dollar range. Overall nice quality.
Most Helpful Negative Review
buy the stock only. forget the kit.
I purchased two of these kits and upon first inspection everything seemed legit. When the tube was installed on the lower i noticed it was slightly canted after tightening the castle nut. When removed you could see where the endplate had cut into the threads. I assumed i had done something wrong so ...
Read More...
Read More...
S4 pro stock
Awesome stock easy installation and honestly i like this stock over my Magpul furniture on my other Rifle came with everything needed and the fitment is super snug and the stock has virtually zero to little play between the stock and the buffer unlike the Magpul that can rattle definitely sticking to these UTG Stocks
Pros:
- Snug
Cons:
- Zero
Best Used for:
- home defeanse
Would recommend: Yes
I bought two, one works and one doesn't
I think this is a decent stock however one that I bought does not securely lock in place in the fully extended position. It seems secure in the farthest position but suddenly slides up a notch when firing. This is disconcerting and causes the slide not to recoil properly, jamming a round halfway into the chamber. I swapped out to the second stock purchased and everything is fine. I haven't been able to figure out why the first one fails based on simple observation. For the price I can tolerate tossing one but check yours thoroughly on the range before trusting this unit on your go-to gun
Pros:
- Sturdy
- minimum slop
Cons:
- Failure to feed
Would recommend: Yes
buffer stock kit
I like this kit especially for the price it functions well is smooth looks good have yet to use the rifle its on but will do that soon.
Would recommend: Yes
great for the price
Perfect for what i needed install was easy and it looks good. Better then some that cost more.
Would recommend: Yes
disappointed with the design
I bought this because it was the complete set i needed and its made in the USA. The overall quality was satisfactory with all the components. I was disappointed with the design of the butt stock. The lever thats used when you adjust the atock is held in by a pin that's not captive to the stud it is supposed to hold the lever secure. From time to time if the stud is not inserted coreectly, that pin will be loose and if you tilt in any direction, the pin will fall out and possibly be lost.
Its a really bad design that i think UTG should take a look at.i wouldnt trust this device in any environment.
Its a really bad design that i think UTG should take a look at.i wouldnt trust this device in any environment.
Would recommend: No
2 of 2 found the following review helpful.
Leapers UTG PRO AR15 S4 Mil-spec Stock Kit good quality one quibble
The Leapers UTG PRO AR15 Ops Ready S4 Mil-spec Stock Kit feels high quality. It doesn't have a lot of slop or rattle like some of the cheaper stock kits. The rubber pad on the stock is comfortable enough. The one issue is that the charging handle can bump the cheek rest.
Would recommend: Yes
2 of 2 found the following review helpful.
Clean look
I have this on a 20" valkyrie and am very impressed. It is very comfortable and holds recoil very well for its size. Gives an excellent look for a streamlined build. Leaves a little bit more of the buffer tube exposed than others that also has a good look when you have a colored or stripped buffer like mine.
Pros:
- All
Cons:
- None
Best Used for:
- Any build
Would recommend: Yes
Something different
Was looking for something different at a good price. Came across these and really like the design, function and quality. I would absolutely buy these again. Everything went together as it should with no problems.
Would recommend: Yes
3 of 3 found the following review helpful.
Threads broke when tightening
Threads broke off the buffer tube when screwing in and ruined my lower..super upset that this happen. I purchased 2 and didn’t even open the 2nd package yet. Both are being returned....................
Would recommend: No
1 of 4 found the following review helpful.
not my thing
I won't say that it is a bad item. It is sturdy and fit on my lower very well, I have to say I am not a big fan of the stock. It is very short, it does not cover all of the adjustment slots on the buffer. And for me it, a man with rather long arms, it just did not work well. It is built well though.
Would recommend: No
1 of 1 found the following review helpful.
There are no reviews that match your criteria. Would you like to review this product?