Reviews & Ratings for Tiger Rock AR Accu Wedge Buffer — 11 reviews — Page 1

This does what its meant to do however it fits much tighter then other ones ive used making it harder to close your rifle up but once you get it it does as its suppose too.

Havent actually used it but just installing it and manually charging the weapon the finish is rubbing off and it sticks more then any bcg ive ever installed not very happy with it. Chinese junk.

Wedge buffer works great but gave it 4 stars because I had to shave it slightly for fitment. Outside of that its awesome. Helps tighten up any wiggle you may have between your upper and lower receivers

Great budget fix to a sloppy rifle fit. Takes some shaving or slicing with a razor blade to fit.

Works as advertised, helps remove the rattle between the upper and lower. Doesn't remove it entirely, I put it in a new AR build I was working on the had a pretty bad rattle. After around 400 rounds, the rattle was back, but not to the extent it was before. It's a cheaper way to help mitigate the rattle

It takes the slop out of the of the upper and lower receiver

I have a couple Aero Precision M4E1 Lowers as well as a Stag Arms AR15 Lower (same as Aero & BA). The little mickey mouse ear bumps on the wedge don't seat properly in those receivers (not sure about others). I had to cut them off and shave the very bottom down to be able to close the upper and lower together. Similar issue to using the set screw in them. Either you remove the slop and can barely move the takedown pin, or it still slops around a bit. I was hoping it would really solidify the mating of the upper and lower, but it really only cleaned up a little more slop and I could get with adjusting the set screw in the lower. So it works and if you have a ton of slop and no set screw, this would be a great product. If you have a set screw and can eliminate most of the slop with that, you won't get much more out of this. Anything more you take out will be balanced with a much harder to use rear takedown pin.

It does exactly what it says tightens up lower and upper receiver it eliminated all wobble on my ar and took less that 60 seconds to install. It may take a little modification with a razor blade to keep from being to tight but even with that it's still very simple to install and it works wonderfully I definitely recommend this to anyone that wants to make sure the receiver wobbleis a past issue

will take the "Play" out of the upper/lower receivers. Mix and match mil-spec receivers will sometimes have slight differences in manufacturing. this causes the receivers to not mate properly. the accu wedge fixes the problem.

It's a little rubber insert that you stick in the back of the lower receiver underneath where the buffer spring goes. I had to shave mine down with a knife in order to get it to fit correctly, but once it did there wasn't nearly as much wobble. It's not a hard necessity but it's nice to have.