Reviews & Ratings for Polymer80 PF-Series Pistol Frame Parts Kit With Trigger Compatible — 24 reviews — Page 1

Bought it for the flat trigger but only kept the pins. I wanted to swap the old trigger on my g17 so i went out on a limb and got this kit. Some people might like this but i would rather have my old oem trigger over this. I ended up gifting all the parts except the pins

LPK is missing main trigger pin and the trigger safety pin, these are mandatory to a lower parts kit. Very upset that I have to go out and buy more small parts when the idea was to buy this kit and be done

I’ve built several P80’s and learned some things about the parts and the importance of certain factory parts vs a kit. While I had to replace maybe 75% of another parts kit - mostly for my slide parts not lower - this one has required only one replacement part. Be aware that this DOES NOT ship with a 9mm ejector as written in the description, but a .45 ejector. I had to track down a 9mm otherwise the rounds will not chamber cleanly and get stuck. I figure it’s a simple, small, yet critical metal piece, probably only a couple bucks. Wrong! The only one I could find, that doesn’t come with a trigger assembly housing (which will run you about $35) is $14. So now this is a ~$70 lower parts kit which is no longer the cheapest you can find. You can I did also note that another review here is accurate… the springs are kinda rusty, though I don’t think it really effects the functionality at all, and if you’re inclined, you can soak the pieces in CLR - I, personally, didn’t waste my time.

I need to know how to get the the page for the trigger assembly and the upper assembly parts I haven't started it yet haven't got the parts that I want that is all I really have to say till I talk to someone in person and also are there better trigger assemblies available and I have a few more questions over the phone with a voice

I am extremely disappointed with this. Every metal part was corroded. I will be planning on returning item. Quite frankly, I cannot even fathom how this even got post anyone's quality control team. Do not waist your money.

I made a P80 for fun and learn, so cant go wrong buying the parts for it by them. I will say the parts did seem a bit cheap but I wasnt really looking for much and choices seem a bit limited without buying each individual part.

I ordered a P80 frame kit and it did not come with this to complete the lower. It worked perfectly everything fits where it’s supposed too and when complete. Several hundred rounds should make it actuate just as smooth as silk. If necessary I would order this again!

This LPK is good for completing any of your PF940 series(full, compact, and sub-compact). You can then run it and make sure you are good to go before upgrading other internal parts. 3 Slide lock springs(full, compact, and sub-compact) and 2 trigger profiles(flat and curved). Polymer80 does have a decent quality and I trust them for my own use.

I bought this for a Grey Ghost 17 and after 600-700 rounds the tip of the striker broke off resulting in an inoperable firearm. It is a cheap cast part. Bought a zev as a replacement so hopefully im good for the next 10,000 rounds.

Given the times we are in this p80 LPK really isn't anything to slouch on. It works to spec and just as good as OEM parts but obviously they are the preferred part we would choose but beggars can't be choosers. Have bought 3 already and plenty of spare parts............................................................................................................