Your Browser is Outdated
Compare (0)
1 item has been added
Add at least two items to compare
Most Helpful Positive Review
Extended bolt release lever.
Works perfectly fine in my rifle. Just pop the rear takedown pin, sandwich the release lever over the original release tab and scew them together. One screw from each side. Then tighten the outside center set screw to fix position. Close rifle, reinstall takedown pin and its done. Took me three minu...
Read More...
Read More...
Most Helpful Negative Review
Installation is more involved than others
It works, but not the best one I have. The design is flawed for installation. You need to take the entire bolt catch out of your firearm....then you can put this thing on because they have a screw BEHIND the original bolt catch between it and the rifle. There is no room whatsoever to do this if you ...
Read More...
Read More...
great alternatve to the other versions, more robust
I’ve installed the magpul BAD, and the phase 5. All three are serviceable so it’s mostly about the Tiger Rock being a little heavier but more robust. The metal itself is thick and there are 2 screws that fasten the lever to the bolt catch on this one but only one screw on the magpul and phase 5.
Pros:
- Price
- Durability
Cons:
- weight?
- finish a little shiny, looks like paint as opposed to cerakote/nitride
Best Used for:
- AR15
Would recommend: Yes
Extremely cheap materials
The two bolts that come with this set up tend to fall out when you're firing your weapon which makes your release essentially useless. When this happens you cannot lock your bolt to the rear even when the gun does it normally upon being empty. Stick with the MAGPUL Bad Lever.
Pros:
- Looks cool
Cons:
- cheap materials
- Complicated set up
Would recommend: No
1 of 2 found the following review helpful.
World perfectly!
This device does everything I expected it to do. For and finish was excellent as well.
Would recommend: Yes
Not as good as Magpul for 30% of cost.
Works as intended. It's a bit sharp on the edges.
I used a file and blued the metal after.
I'd spend the extra for magpul unless you're just having fun.
I used a file and blued the metal after.
I'd spend the extra for magpul unless you're just having fun.
Would recommend: Yes
EASY INSTALL STURDY PRODUCT
I have one of these on three of my AR's. It makes everything so much easier whether you are right or left handed.
At this price there is no reason no to try it.
I highly recommend it.
At this price there is no reason no to try it.
I highly recommend it.
Pros:
- easy of operation
Cons:
- None so far
Best Used for:
- all shooting activities
Would recommend: Yes
Meh, didn’t care for them
I bought two for two different rifles. Both loosened up at maybe 30 rounds. Tightened back up and seemed like it wanted to break if you went too tight. A bit sloppy when it is tight. Recently bought a Magpul BAT which is similar design but much better fit and feel. Wouldn’t buy these again.
Would recommend: No
Bolt release
Awesome addition to my msr. Less than 5 minute install.will but again
Pros:
- EASY INSTALL
Cons:
- Paint comes off easily
- Paint rubs off easy
Would recommend: Yes
Heck of a deal
I know someone said you needed to have the bolt catch out of the gun to install this but they obviously didn't think to take the upper off because you definitely can. Either way, it is easy and the set screw makes sure it is as tight as can be. I almost like it better than the B.A.D. levers i have.
Would recommend: Yes
1 of 1 found the following review helpful.
Better than B.A.D.
More affordable than Magpul and works just the same! Love it!
Pros:
- quicker reload
Cons:
- None
Would recommend: Yes
There are no reviews that match your criteria. Would you like to review this product?